LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (2 Of 3)) >> DTC/Circuit Diagnosis >> DTC P1078, P1084: EVT Control Position Sensor >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK DTC PRIORITY

    If DTC P1078 or P0184 is displayed with DTC P0643, first perform the confirmation procedure (trouble diagnosis) for DTC P0643.

    Is applicable DTC detected?

    YES 

    Perform diagnosis of applicable. Refer to DTC LOGIC .

    NO 

    GO TO STEP 2  .

  2. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO STEP 3  .

  3. PERFORM DTC CONFIRMATION PROCEDURE

    1. Start engine and let it idle for 10 seconds.
    2. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO - 1 

    To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

    NO - 2 

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals