LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (2 Of 3)) >> DTC/Circuit Diagnosis >> DTC P052A, P052B, P052C, P052D: Intake Valve Timing Control >> Component Inspection (Camshaft Position Sensor) >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK CAMSHAFT POSITION SENSOR (PHASE)-1

    1. Turn ignition switch OFF.
    2. Loosen the fixing bolt of the sensor.
    3. Disconnect camshaft position sensor (PHASE) harness connector.
    4. Remove the sensor.
    5. Visually check the sensor for chipping.
      G04886800Courtesy of NISSAN NORTH AMERICA, INC.

    Is the inspection result normal?

    YES 

    GO TO STEP 2  .

    NO 

    Replace camshaft position sensor (PHASE).

  2. CHECK CAMSHAFT POSITION SENSOR (PHASE)-2

    Check the resistance camshaft position sensor (PHASE) terminals as per the following.

    Camshaft position sensor (PHASE) Resistance [Ω at 25°C (77°F)]
    + -
    Terminals (Polarity)
    1 2 Except 0 or ∞
    3
    2 3

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace camshaft position sensor (PHASE). Refer to REMOVAL AND INSTALLATION (LH) , REMOVAL AND INSTALLATION (RH) .

scientia non olet · About LEMON Manuals