LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (2 Of 3)) >> DTC/Circuit Diagnosis >> DTC P050A, P050E: Cold Start Control >> Diagnosis Procedure >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. PERFORM IDLE AIR VOLUME LEARNING

    Perform DESCRIPTION .

    Is Idle Air Volume Learning carried out successfully?

    YES 

    GO TO STEP 2  .

    NO 

    Follow the instruction of Idle Air Volume Learning.

  2. CHECK Intake system

    Check for the cause of intake air volume lacking. Refer to the following.

    • Crushed intake air passage
    • Intake air passage clogging
    • Clogging of throttle body

    Is the inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Repair or replace malfunctioning part

  3. CHECK FUEL INJECTION SYSTEM FUNCTION

    Perform DTC Confirmation Procedure for DTC P0171, P0174. Refer to DTC LOGIC .

    Is the inspection result normal?

    YES 

    GO TO STEP 4  .

    NO 

    Proceed to DIAGNOSIS PROCEDURE  for DTC P0171, P0174.

  4. PERFORM DTC CONFIRMATION PROCEDURE

    1. Turn ignition switch ON.
    2. Erase DTC.
    3. Perform DTC Confirmation Procedure.

      See DTC LOGIC .

    Is the 1st trip DTC P050A, P050E displayed again?

    YES 

    Replace ECM. Refer to REMOVAL AND INSTALLATION .

    NO 

    INSPECTION END