LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (2 Of 3)) >> DTC/Circuit Diagnosis >> DTC P0500: VSS >> DTC Logic >> DTC Detection Logic

DTC Detection Logic

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • If DTC P0500 is displayed with DTC UXXXX, first perform the trouble diagnosis for DTC UXXXX.
  • If DTC P0500 is displayed with DTC P0607, first perform the trouble diagnosis for DTC P0607. Refer to DTC LOGIC .
DTC No. CONSULT screen terms
(Trouble diagnosis content)		 DTC detecting condition Possible cause
P0500 VEH SPEED SEN/CIRC
(Vehicle speed sensor "A")		 At 20 km/h (13 MPH), ECM detects the following status continuously for 5 seconds or more: The difference between a vehicle speed calculated by a output speed sensor transmitted from TCM to ECM via CAN communication and the vehicle speed indicated on the combination meter exceeds 15km/h (10 MPH).
  • Harness or connector

    (The CAN communication line is open or shorted.)

  • Combination meter
  • ABS actuator and electric unit (control unit)
  • Wheel sensor
  • TCM
  • Output speed sensor
scientia non olet · About LEMON Manuals