LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (2 Of 3)) >> DTC/Circuit Diagnosis >> DTC P0448: EVAP Canister Vent Control Valve >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO STEP 2. 

  2. PERFORM DTC CONFIRMATION PROCEDURE

    G-20With CONSULT 

    1. Turn ignition switch ON and wait at least 5 seconds.
    2. Turn ignition switch OFF and wait at least 10 seconds.
    3. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT.
    4. Start engine and let it idle for at least 1 minute.
    5. Repeat next procedures 3 times.
      1. Increase the engine speed up to 3, 000 to 3, 500 RPM and keep it for 2 minutes and 50 seconds to 3 minutes.

        Never exceed 3 minutes. 

      2. Fully released accelerator pedal and keep engine idle for about 5 seconds.
    6. Repeat next procedure 20 times.
      • Quickly increase the engine speed up to 4, 000 to 4, 500 RPM or more and keep it for 25 to 30 seconds.
      • Fully released accelerator pedal and keep engine idle for at least 35 seconds.
        G04074140Courtesy of NISSAN NORTH AMERICA, INC.
    7. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals