LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 117 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (2 Of 3)) >> DTC/Circuit Diagnosis >> DTC P0181: FTT Sensor >> Component Inspection >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK FUEL TANK TEMPERATURE SENSOR

    1. Turn ignition switch OFF.
    2. Remove fuel level sensor unit. Refer to REMOVAL AND INSTALLATION .
    3. Check resistance between "fuel level sensor unit and fuel pump" terminals by heating with hot water as shown in illustration.
      G00498927Courtesy of NISSAN NORTH AMERICA, INC.
      Mass air flow sensor Condition Resistance (kΩ)
      + -
      Terminals
      3 1 Temperature [°C (°F)] 20 (68) 2.3 - 2.7 kΩ
      50 (122) 0.79 - 0.90 kΩ

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace fuel level sensor unit and fuel pump. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals