LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (3 Of 3)) >> DTC/Circuit Diagnosis >> ICC Brake Switch >> Component Inspection (ICC Brake Hold Relay) >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK ICC BRAKE HOLD RELAY

    1. Turn ignition switch OFF.
    2. Remove ICC brake hold relay.
    3. Check the continuity between ICC brake hold relay terminals under the following conditions.
      G05733515Courtesy of NISSAN NORTH AMERICA, INC.
      Terminals Condition Continuity
      3 and 5 12V direct current supply between terminals 1 and 2 Existed
      No current supply Not existed

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace ICC brake hold relay

scientia non olet · About LEMON Manuals