LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (3 Of 3)) >> DTC/Circuit Diagnosis >> Fuel Pump >> Component Inspection (Fuel Pump) >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK FUEL PUMP

    1. Turn ignition switch OFF.
    2. Disconnect "fuel level sensor unit (fuel pump)" harness connector.
    3. Check resistance between "fuel level sensor unit (fuel pump)" terminals as follows.
      Terminals Resistance [at 25°C (77°F)]
      4 and 6 0.2 - 5.0 Ω

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace fuel level sensor unit, fuel filter and fuel pump assembly. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals