Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ELECTRONIC CONTROLLED ENGINE MOUNT CONTROL SOLENOID VALVE

With CONSULT

Turn ignition switch OFF.
Reconnect electronic controlled engine mount control solenoid valve harness connector.
Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.
Turn ignition switch ON.
Select "ENGINE MOUNTING" in "ACTIVE TEST" mode with CONSULT.

Check air passage continuity and operation delay time under the following conditions.

Courtesy of NISSAN NORTH AMERICA, INC.

Condition (ENGINE MOUNTING)	Air passage continuity between and	Air passage continuity between and
TRVL	Existed	Not existed
IDLE	Not existed	Existed

Without CONSULT

Turn ignition switch OFF.
Disconnect electronic controlled engine mount control solenoid valve harness connector.
Disconnect vacuum hoses connected to electronic controlled engine mount control solenoid valve.

Check air passage continuity and operation delay time under the following conditions.

Courtesy of NISSAN NORTH AMERICA, INC.

Condition	Air passage continuity between and	Air passage continuity between and
12 V direct current supply between terminals 1 and 2	Existed	Not existed
No supply	Not existed	Existed

Is the inspection result normal?

YES

INSPECTION END

Replace electronic controlled engine mount control solenoid valve. Refer to COMPONENT PARTS LOCATION .