LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (3 Of 3)) >> DTC/Circuit Diagnosis >> DTC P2135: TP Sensor >> Component Inspection >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK THROTTLE POSITION SENSOR

    1. Turn ignition switch OFF.
    2. Reconnect all harness connectors disconnected.
    3. Perform DESCRIPTION .
    4. Turn ignition switch ON.
    5. Shift selector lever position to D.
    6. Check the voltage between ECM harness connector terminals under the following conditions.
      ECM Condition Voltage
      Connector + -
      Terminal
      F79 71 75 Accelerator pedal Fully released More than 0.36 V
      Fully depressed Less than 4.75 V
      72 Fully released Less than 4.75 V
      Fully depressed More than 0.36 V

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace electric throttle control actuator. Refer to REMOVAL AND INSTALLATION .

scientia non olet · About LEMON Manuals