LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (3 Of 3)) >> DTC/Circuit Diagnosis >> DTC P1715: Input Speed Sensor (Primary Speed Sensor) >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO STEP 2  .

  2. PERFORM DTC CONFIRMATION PROCEDURE

    1. Start engine.
    2. Drive vehicle at a speed of more than 50 km/h (31 MPH) for at least 5 seconds.
    3. Check 1st trip DTC.

    Is 1st trip DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals