LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (3 Of 3)) >> DTC/Circuit Diagnosis >> DTC P1564: ICC Steering Switch >> Component Inspection (ICC Steering Switch) >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK ICC STEERING SWITCH

    1. Turn ignition switch OFF.
    2. Disconnect combination switch (spiral cable) harness connector M303.
    3. Check resistance between combination switch harness connector terminals under the following conditions.
      Combination switch Condition Resistance (Ω)
      Connector Terminals
      M149 13 and 16 ON/OFF (MAIN) switch: Pressed Approx. 0
      CANCEL switch: Pressed Approx. 270
      COAST/SET switch: Pressed Approx. 620
      ACCEL/RES switch: Pressed Approx. 1, 100
      DYNAMIC DRIVE ASSISTANCE switch: Pressed Approx. 1, 810
      DISTANCE switch: Pressed Approx. 3, 000
      All ICC steering switches: Released Approx. 5, 420

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Replace ICC steering switch. Refer to EXPLODED VIEW .

scientia non olet · About LEMON Manuals