LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (3 Of 3)) >> DTC/Circuit Diagnosis >> DTC P1564: ASCD Steering Switch >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. PRECONDITIONING

    If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next test.

    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.

    GO TO STEP 2. 

  2. PERFORM DTC CONFIRMATION PROCEDURE

    1. Turn ignition switch ON and wait at least 10 seconds.
    2. Press MAIN switch for at least 10 seconds, then release it and wait at least 10 seconds.
    3. Press CANCEL switch for at least 10 seconds, then release it and wait at least 10 seconds.
    4. Press RESUME/ACCELERATE switch for at least 10 seconds, then release it and wait at least 10 seconds.
    5. Press SET/COAST switch for at least 10 seconds, then release it and wait at least 10 seconds.
    6. Check DTC.

    Is DTC detected?

    YES 

    Proceed to DIAGNOSIS PROCEDURE .

    NO 

    INSPECTION END

scientia non olet · About LEMON Manuals