LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Engine Control System (DTC/Circuit Diagnosis) (VQ35DE) (Except Hybrid) (3 Of 3)) >> DTC/Circuit Diagnosis >> Brake Pedal Position Switch >> Component Function Check >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK BRAKE PEDAL POSITION SWITCH FUNCTION

    G-20With CONSULT 

    1. Turn ignition switch ON.
    2. Select "BRAKE SW1" in "DATA MONITOR" mode with CONSULT.
    3. Check "BRAKE SW1" indication under the following conditions.
      Monitor item Condition Indication
      BRAKE SW1 Brake pedal Slightly depressed OFF
      Fully released ON

    G-21Without CONSULT 

    1. Turn ignition switch ON.
    2. Check the voltage between ECM harness connector terminals.
      ECM Condition Voltage
      Connector + -
      Terminal
      E32 140 152 Brake pedal Slightly depressed Approx. 0 V
      Fully released Battery voltage

    Is the inspection result normal?

    YES 

    INSPECTION END

    NO 

    Proceed to DIAGNOSIS PROCEDURE .

scientia non olet · About LEMON Manuals