Diagnosis Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

CHECK PUSH-BUTTON IGNITION SWITCH SIGNAL (PUSH-BUTTON IGNITION SWITCH)

Check voltage between push-button ignition switch connector M17 and ground.

Push-button ignition switch		Ground	Voltage (Approx.)
Connector	Terminal
M17	8	-	Battery voltage

Is the inspection result normal?

YES

GO TO STEP 2 .

GO TO STEP 3 .

CHECK PUSH-BUTTON IGNITION SWITCH SIGNAL (IPDM E/R)

Check voltage between IPDM E/R connector E119 and ground.

IPDM E/R		Ground	Voltage (Approx.)
Connector	Terminal
E119	38	-	Battery voltage

Is the inspection result normal?

YES

Replace IPDM E/R. Refer to REMOVAL AND INSTALLATION .

Repair or replace harness or connectors.

CHECK PUSH-BUTTON IGNITION SWITCH SIGNAL CIRCUIT (PUSH-BUTTON IGNITION SWITCH)

Disconnect push-button ignition switch connector, IPDM E/R connector E119 and BCM connector M18.

Check continuity between BCM connector M18 and push-button ignition switch connector M17.

BCM		Push-button ignition switch		Continuity
Connector	Terminal	Connector	Terminal	Continuity
M18	1	M17	8	Yes

Check continuity between BCM connector M18 and ground.

BCM		Ground	Continuity
Connector	Terminal
M18	1	-	No

Is the inspection result normal?

YES

Replace BCM. Refer to REMOVAL AND INSTALLATION .

Repair or replace harness or connectors.