Inspection And Repair: Inspection

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

When measuring voltage, wrap tin foil around the top of the negative probe. Then press the foil against the wire with your finger.

Courtesy of NISSAN NORTH AMERICA, INC.
Attach probe circuit tester (in Volt range) to middle portion of each filament.

Courtesy of NISSAN NORTH AMERICA, INC.
If a filament is burned out, circuit tester registers 0 or battery voltage.

Courtesy of NISSAN NORTH AMERICA, INC.
To locate burned out point, move probe to left and right along filament. Test needle will swing abruptly when probe passes the point.