Diagnosis Procedure
Regarding Wiring Diagram information, refer to WIRING DIAGRAM .
- CHECK POWER SUPPLY
Check if the following fuse in the fuse block (J/B) is blown.
COMPONENT PARTS AMPERE FUSE NO. Fuse block (J/B) 10A 22 Is the inspection result normal?
YES
GO TO STEP 2 .
NO
If fuse is blown, be sure to eliminate cause of malfunction before installing new fuse.
- CHECK DOOR MIRROR DEFOGGER POWER SUPPLY CIRCUIT
- Turn ignition switch OFF.
- Disconnect door mirror RH.
- Turn ignition switch ON.
- Check voltage between door mirror RH connector D107 terminal 1 and ground.
(+) (-) Condition Voltage (V)
(Approx.)Door mirror RH Connector Terminal D107 1 Ground Rear window defogger switch ON Battery voltage OFF 0 Is the inspection result normal?
YES
GO TO STEP 3.
NO
Repair or replace harness.
- CHECK DOOR MIRROR DEFOGGER GROUND CIRCUIT
- Turn ignition switch OFF.
- Check continuity between door mirror RH connector and ground.
Door mirror RH Ground Continuity Connector Terminal D107 2 Yes
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Repair or replace harness.
- CHECK DOOR MIRROR DEFOGGER RH
Check door mirror defogger RH.
Refer to COMPONENT INSPECTION .
Is the inspection result normal?
YES
GO TO STEP 5 .
NO
Replace door mirror RH. Refer to REMOVAL AND INSTALLATION .
- CHECK INTERMITTENT INCIDENT
Check intermittent incident.
Refer to INTERMITTENT INCIDENT .
Is the inspection result normal?
YES
Check the following:
- Battery power supply circuit
- Fuse block (J/B)
NO
Repair or replace the malfunctioning parts.