Data Monitor
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
| Monitor Item | Unit | Description |
|---|---|---|
| SPINDLE SENSOR LH | [Pulse] | Displays the condition of the LH encoder |
| SPINDLE LH SPEED | [mm/s] | Displays the LH spindle operation speed |
| SPINDLE MOTOR LH DUTY | [%] | Displays the condition of the spindle motor LH duty |
| VHCL SPEED MTR | [km/h] | Displays the vehicle speed signal received from combination meter by numerical value |
| VHCL SPEED ABS | [km/h] | Displays the vehicle speed signal received from ABS actuator and electrical unit by numerical value |
| MAIN SW | [ON/OFF] | Indicates condition of automatic back door main switch |
| AUTO BD SW | [ON/OFF] | Indicates condition of automatic back door switch |
| BK DOOR CL SW | [ON/OFF] | Indicates condition of automatic back door close switch |
| PKB SW | [ON/OFF] | Indicates condition of parking brake switch |
| BACK DOOR LOCK STATUS | [ON/OFF] | Indicates condition of back door lock status |
| OPEN SW | [ON/OFF] | Indicates condition of open switch |
| CLOSE SW | [ON/OFF] | Indicates condition of close switch |
| HALF LATCH SW | [ON/OFF] | Indicates condition of half latch switch |
| TOUCH SEN RH | [ON/OFF/OPEN] | Indicates condition of touch sensor RH |
| TOUCH SEN LH | [ON/OFF/OPEN] | Indicates condition of touch sensor LH |
| P RANGE IND | [ON/OFF] | Indicates condition of P range signal from combination meter |
| RKE REQ | [OFF/MOVE/REV] | Indicates condition of remote keyless entry signal from BCM |
| IGN SW | [ON/OFF] | Indicates condition of IGN power supply |
| SPINDLE LH ENCODER A | [LO/HI] | Indicates condition of encoder signal from encoder A |
| SPINDLE LH ENCODER B | [LO/HI] | Indicates condition of encoder signal from encoder B |
| DESTINATION | [JPN/NAM] | Indicates specification of destination of the automatic back door system |
| AUTO BCK DR POS INITIAL | [YET/DONE] | Indicates condition of calibration of automatic back door position information |
| AUTO BCK DR POS LEARN | [YET/DONE] | Indicates condition of additional service when removing battery negative cable |
| SPINDLE SENSOR RH | [Pulse] | Displays the condition of the RH encoder |
| SPINDLE RH SPEED | [mm/s] | Displays the RH spindle operation speed |
| SPINDLE MOTOR RH DUTY | [%] | Displays the condition of the spindle motor RH duty |
| SPINDLE RH ENCODER A | [LO/HI] | Indicates condition of encoder signal from encoder A |
| SPINDLE RH ENCODER B | [LO/HI] | Indicates condition of encoder signal from encoder B |