LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Door & Lock (Introduction, Wiring Diagrams And Basic Inspection) (Except Hybrid)) >> Basic Inspection >> Calibration Of Automatic Back Door Position Information >> Work Procedure

Work Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. STEP 1

    Fully close the back door manually.

    GO TO STEP 2. 

  2. STEP 2

    1. Select "AUTO BACK DOOR " using CONSULT.
    2. Select "RESET AUTO BACK DOOR STATUS" of "WORK SUPPORT" mode.
    3. Touch "START" to erase automatic back door position information.

    GO TO STEP 3. 

  3. STEP 3

    Operate back door opener switch and perform automatic open operation.

    NOTE:

    At this time, automatic operation of back door is performed at half speed.

    GO TO STEP 4. 

  4. STEP 4

    1. The back door fully opens.
    2. Check that hazard warning lamp blinks and automatic back door warning buzzer sounds normally.

    Does hazard warning lamp blink and automatic back door warning buzzer sound normally?

    YES 

    GO TO STEP 5. 

    NO 

    GO TO STEP   1 . 

  5. STEP 5

    Fully close the back door.

    Inspection End.

scientia non olet · About LEMON Manuals