Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION OPERATION
   
   

   CONSULT

   1. Turn the ignition switch ON.
   2. Select ENGINE SW ILLUMI of BCM (INTELLIGENT KEY) active test item.
   3. While operating the test item, check voltage between push-button ignition switch connector M17 terminal 5 and ground.

   Terminals			Test item	Voltage (Approx.)
   (+)		(-)
   Push-button ignition switch		Ground	ENGINE SW ILLUMI
   Connector	Terminal
   M17	5		ON	5 V
   			OFF	0 V

   Is the inspection result normal?

   YES 

   GO TO STEP 4 

   NO 

   GO TO STEP 2 

2. CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION POWER SUPPLY OPEN CIRCUIT
   
   
   1. Turn the ignition switch OFF.
   2. Disconnect BCM harness connector M19 and the push-button ignition switch harness connector M17.
   3. Check continuity between BCM harness connector M19 terminal 48 and the push-button ignition switch harness connector M17 terminal 5.

   BCM		Push-button ignition switch		Continuity
   Connector	Terminal	Connector	Terminal
   M19	48	M17	5	Yes

   Is the inspection result normal?

   YES 

   GO TO STEP 3 

   NO 

   Repair or replace harness or connectors.

3. CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION POWER SUPPLY SHORT CIRCUIT
   
   

   Check continuity between BCM harness connector M19 terminal 48 and ground.

   BCM		Ground	Continuity
   Connector	Terminal
   M19	48		No

   Is the inspection result normal?

   YES 

   Replace BCM. Refer to REMOVAL AND INSTALLATION .

   NO 

   Repair or replace harness or connectors.

4. CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION GROUND CIRCUIT
   
   
   1. Turn the ignition switch OFF.
   2. Disconnect push-button ignition switch harness connector M17.
   3. Check continuity between push-button ignition switch harness connector M17 terminal 6 and ground.

      Push-button ignition switch		Ground	Continuity
      Connector	Terminal
      M17	6		Yes

   Is the inspection result normal?

   YES 

   Replace push-button ignition switch. Refer to REMOVAL AND INSTALLATION .

   NO 

   GO TO STEP 5 

5. CHECK PUSH-BUTTON IGNITION SWITCH ILLUMINATION GROUND OPEN CIRCUIT
   
   
   1. Disconnect BCM harness connector M80.
   2. Check continuity between BCM harness connector M80 terminal 107 and push-button ignition switch harness connector M17 terminal 6.

      Push-button ignition switch		BCM		Continuity
      Connector	Terminal	Connector	Terminal
      M17	6	M80	107	Yes

   Is the inspection result normal?

   YES 

   Replace BCM. Refer to REMOVAL AND INSTALLATION .

   NO 

   Repair or replace harness or connectors.