LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Driver Assistance System (Introduction, Wiring Diagrams And Basic Inspection) (BCI) (Except Hybrid)) >> DTC/Circuit Diagnosis >> C1A03 Vehicle Speed Sensor >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. PERFORM DTC CONFIRMATION PROCEDURE

    1. Start the engine.
    2. Turn the Blind Spot Intervention system ON.
    3. Drive the vehicle at 30 km/h (19 MPH) or more.
      CAUTION:

      Always drive safely.

    4. Stop the vehicle.
    5. Perform "All DTC Reading" with CONSULT.
    6. Check if the "C1A03" is detected as the current malfunction in "Self Diagnostic Result" of "ICC/ADAS".

    Is "C1A03" detected as the current malfunction?

    YES-1 (Blind Spot Warning/Blind Spot Intervention warning lamp: ON) 

    Refer to DIAGNOSIS PROCEDURE .

    YES-2 (Blind Spot Warning/Blind Spot Intervention warning lamp: OFF) 

    Refer to DTC LOGIC .

    NO 

    Refer to INTERMITTENT INCIDENT .

scientia non olet · About LEMON Manuals