LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 102 (Driver Assistance System (Introduction, Wiring Diagrams And Basic Inspection) (BCI) (Except Hybrid)) >> Basic Inspection >> Pre-Inspection For Diagnosis >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

  1. CHECK SONAR SENSORS INSTALLATION ON THE REAR BUMPER COVER

    Are there any foreign materials obstructing the view of any sonar sensor?

    YES 

    Clean the rear bumper and the sonar detection window.

    NO 

    GO TO STEP 2. 

  2. CHECK REAR BUMPER NEAR THE SIDE RADAR

    Are rear bumper near the side radar contaminated with foreign materials?

    YES 

    Clean the rear bumper.

    NO 

    GO TO STEP 3  .

  3. CHECK SIDE RADAR AND THE SIDE RADAR OUTSKIRTS

    Are side radar and the side radar outskirts contaminated with foreign materials?

    YES 

    Clean the side radar or side radar outskirts.

    NO 

    GO TO STEP 4  .

  4. CHECK SIDE RADAR INSTALLATION CONDITION

    Check side radar installation condition (installation position, properly tightened, a bent bracket).

    Is it properly installed?

    YES 

    Inspection End.

    NO 

    Install side radar properly.

scientia non olet · About LEMON Manuals