LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Wiper & Washer (Except Hybrid)) >> System Description >> Diagnosis System (IPDM E/R) >> Diagnosis Description >> Auto Active Test >> Operation Procedure

Operation Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

Do not start the engine.

NOTE:

When auto active test is performed with hood opened, sprinkle water on windshield before hand.

NOTE:
  • If auto active test mode cannot be actuated, check door switch system. Refer to COMPONENT FUNCTION CHECK .
  • When auto active test mode has to be cancelled halfway through test, turn ignition switch OFF.
  1. Close the hood and lift the wiper arms from the windshield. (Prevent windshield damage due to wiper operation)
  2. Turn ignition switch OFF.
  3. Turn the ignition switch ON, and within 20 seconds, press the front door switch LH 10 times. Then turn the ignition switch OFF.
  4. Turn the ignition switch ON within 10 seconds. After that the horn sounds once, and the auto active test starts.
  5. After a series of the following operations is repeated 3 times, auto active test is completed.
scientia non olet · About LEMON Manuals