LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> QX60 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Wiper & Washer (Except Hybrid)) >> Removal And Installation >> Rear Washer Nozzle And Tube >> Removal And Installation - Rear Washer Tube >> Removal

Removal And Installation - Rear Washer Tube: Removal

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the luggage side lower finisher (RH only). Refer to REMOVAL AND INSTALLATION .
  2. Remove the storage box side finisher (LH/RH). Refer to REMOVAL AND INSTALLATION .
  3. Remove the back door kicking plate. Refer to REMOVAL AND INSTALLATION .
  4. Remove the fender protector (RH only). Refer to REMOVAL AND INSTALLATION .
  5. Remove the front kicking plate (RH only). Refer to REMOVAL AND INSTALLATION - FRONT KICKING PLATE .
  6. Remove the rear kicking plate (RH only). Refer to REMOVAL AND INSTALLATION - REAR KICKING PLATE .
  7. Remove the third row seat. Refer to REMOVAL AND INSTALLATION .
  8. Remove the back pillar finisher (RH only). Refer to REMOVAL AND INSTALLATION .
    CAUTION:

    Do not reuse back pillar finisher.

  9. Remove the high-mounted stop lamp. Refer to REMOVAL AND INSTALLATION .
  10. Disconnect the rear washer tube from the rear washer nozzle.
  11. Remove the rear washer tube.
scientia non olet · About LEMON Manuals