Diagnosis Procedure

1. Start the engine.
2. Check that "MAIN SW" and "CRUISE LAMP" operate normally in "DATA MONITOR" of "ICC/ADAS" with CONSULT.

Is the inspection result normal?

YES 

GO TO STEP 2. 

NO 

GO TO STEP   4 . 

Check that "CRUISEIND" operates normally in "DATA MONITOR" of "METER/M&A".

Is the inspection result normal?

YES 

GO TO STEP 3. 

NO 

GO TO STEP   4 . 

1. Perform "Self Diagnostic Result" of "METER/M&A".
2. Check if DTC is detected. Refer to DTC INDEX .

Is any DTC detected?

YES 

Repair or replace malfunctioning parts.

NO 

GO TO STEP 4. 

1. Perform "All DTC Reading".
2. Check if the "U1000" is detected in self-diagnosis results of "ICC/ADAS".

Is "U1000" detected?

YES 

GO TO STEP 5. 

NO 

GO TO STEP   6 . 

Check the CAN communication and repair or replace malfunctioning parts. Refer to DTC LOGIC .

INSPECTION END

Check the ICC steering switch. Refer to COMPONENT INSPECTION .

INSPECTION END