Work Procedure

With CONSULT:

Select "Reprogramming, Configuration" of sonar control unit.

When writing saved data 

GO TO STEP 2  .

When writing manually 

GO TO STEP   3  .

With CONSULT:

Automatically "Operation Log Selection" window will display if "Before Replace ECU" was performed. Select applicable file from the "Save Data List" and press "Confirm".

Work End.

With CONSULT:

1. Select "After Replace ECU" or "Manual Configuration".
2. Identify the correct model and configuration list. Refer to CONFIGURATION LIST .
3. Confirm and/or change setting value for each item.
   CAUTION:

   Thoroughly read and understand the vehicle specification. ECU control may not operate normally if the setting is not correct.

4. Select "Next".
   CAUTION:

   Make sure to select "Next", confirm each setting value and press "OK" even if the indicated configuration of brand new sonar control unit is same as the desirable configuration. If not, configuration which is set automatically by selecting vehicle model can not be memorized.

5. When "Completed", select "End".

GO TO STEP 4  .

Confirm that each function controlled by sonar control unit operates normally.

Work End.