Element Check

Attach probe circuit tester (ohm setting) to antenna terminal on each side.

Fig 1: Attaching Probe Circuit Tester To Antenna Terminal
Courtesy of NISSAN NORTH AMERICA, INC.
- When measuring continuity, wrap tin foil around the top of probe. Then, press the foil against the wire with your finger.
  
  Fig 2: Wrapping Tin Foil Around Top Of Probe
  Courtesy of NISSAN NORTH AMERICA, INC.
If an element is broken, no continuity will exist.

Fig 3: Attaching Probe Circuit Tester To Antenna Broken Terminal
Courtesy of NISSAN NORTH AMERICA, INC.
To locate a break, move probe along element. Tester indication will change abruptly when probe passes the broken point.

Fig 4: Moving Probe Along Element
Courtesy of NISSAN NORTH AMERICA, INC.