Diagnosis Procedure

Regarding Wiring Diagram information, refer to WIRING DIAGRAM .

1. CHECK FUSES
   
   

   Check if any of the following fuses are blown:

   Signal name	Fuse No.
   Battery power supply	75

   Is the inspection result normal?

   YES 

   GO TO STEP 2. 

   NO 

   Replace the blown fuse after repairing the affected circuit if a fuse is blown.

2. CHECK ACCELERATOR PEDAL ACTUATOR POWER SUPPLY CIRCUIT
   
   

   Check voltage between accelerator pedal actuator harness connector and ground.

   Terminal			Condition	Voltage (Approx.)
   (+)		(-)
   Accelerator pedal actuator		Ground	Ignition switch
   Connector	Terminal
   E74	1		OFF	Battery voltage
   	2		ON

   Is the inspection result normal?

   YES 

   GO TO STEP 3. 

   NO 

   Repair the accelerator pedal actuator power supply circuit.

3. CHECK ACCELERATOR PEDAL ACTUATOR GROUND CIRCUIT
   
   
   1. Turn the ignition switch OFF.
   2. Disconnect the accelerator pedal actuator connector.
   3. Check for continuity between accelerator pedal actuator harness connector and ground.

      Accelerator pedal actuator		Ground	Continuity
      Connector	Terminal
      E74	7		Yes

   Is the inspection result normal?

   YES 

   INSPECTION END

   NO 

   Repair the accelerator pedal actuator ground circuit.