DTC Confirmation Procedure

1. Start the engine.
2. Perform the active test item "STOP LAMP" with CONSULT.
3. Perform "All DTC Reading".
4. Check if the "C1A13" is detected as the current malfunction in the "Self Diagnostic Result" of "ICC/ADAS".

Is "C1A13" detected as the current malfunction?

YES 

Refer to DIAGNOSIS PROCEDURE .

NO 

GO TO STEP 2. 

1. Drive at the vehicle speed of 40 km/h (25 MPH) or more for approximately 60 seconds or more without the brake pedal depressed.
   CAUTION:

   Always drive safely.

   NOTE:

   If it is outside the above condition, repeat step 1.

2. Perform "All DTC Reading".
3. Check if the "C1A13" is detected as the current malfunction in the "Self Diagnostic Result" of "ICC/ADAS".

Is "C1A13" detected as the current malfunction?

YES 

Refer to DIAGNOSIS PROCEDURE .

NO 

Refer to INTERMITTENT INCIDENT .