Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect malfunctioning door switch connector.
3. Check signal between malfunctioning door switch harness connector and ground using oscilloscope.

   (+)			(-)	Signal (Reference value)
   Door switch
   Connector		Terminal
   Driver side	B16	2	Ground	Courtesy of NISSAN NORTH AMERICA, INC.
   Passenger side	B216			Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES 

GO TO STEP 3  .

NO 

GO TO STEP 2  .

1. Disconnect BCM connector.
2. Check continuity between door switch harness connector and BCM harness connector.

   Door switch			BCM		Continuity
   Connector		Terminal	Connector	Terminal
   Driver side	B16	2	M123	150	Existed
   Passenger side	B216			124

3. Check continuity between door switch harness connector and ground.

   Door switch			Ground	Continuity
   Connector		Terminal
   Driver side	B16	2		Not existed
   Passenger side	B216

Is the inspection result normal?

YES 

Replace BCM. Refer to REMOVAL AND INSTALLATION .

NO 

Repair or replace harness.

Check continuity between door switch harness connector and ground.

Is the inspection result normal?

YES 

GO TO STEP 4  .

NO 

Repair or replace harness.

Refer to COMPONENT INSPECTION .

Is the inspection result normal?

YES 

GO TO STEP 5  .

NO 

Replace malfunctioning door switch. Refer to REMOVAL AND INSTALLATION .

Refer to INTERMITTENT INCIDENT .

INSPECTION END