Diagnosis Procedure (M/T Models)

1. Turn ignition switch ON.
2. Check the voltage and waveform between combination meter harness connector terminal and ground.

   Terminals			Condition	Voltage (Approx.)
   (+)		(-)
   Combination meter
   Connector	Terminal
   M53	27	Ground	Parking brake applied	0 V
   			Parking brake released	Courtesy of NISSAN NORTH AMERICA, INC.

Is the inspection result normal?

YES 

INSPECTION END

NO 

GO TO STEP 2. 

1. Turn ignition switch OFF.
2. Disconnect combination meter connector and parking brake switch connector.
3. Check continuity between combination meter harness connector terminal and parking brake switch harness connector terminal.

   Combination meter		Parking brake switch		Continuity
   Connector	Terminal	Connector	Terminal
   M53	27	B14	1	Existed

4. Check continuity between combination meter harness connector terminal and ground.

   Combination meter		Ground	Continuity
   Connector	Terminal
   M53	27		Not existed

Is the inspection result normal?

YES 

INSPECTION END

NO 

Repair harness or connector.