Diagnosis Procedure

1. Turn the ignition switch ON.
2. Measure voltage between the following terminals of the combination meter.

   Combination meter			Condition	Voltage (Approx.)
   Connector	Terminal
   	(+)	(-)
   M53	36	16	When (select) switch is pressed	0 V
   			Other than the above	5 V
   	37	16	When (enter) switch is pressed	0 V
   			Other than the above	5 V
   	38	16	When trip A/B reset switch is pressed	0 V
   			Other than the above	5 V
   	39	16	When (illumination control) switch is pressed	0 V
   			Other than the above	5 V
   	40	16	When (illumination control) switch is pressed	0 V
   			Other than the above	5 V

Is the inspection result normal?

YES 

INSPECTION END

NO 

GO TO STEP 2. 

1. Turn the ignition switch OFF.
2. Disconnect the combination meter and meter control switch connectors.
3. Check continuity between combination meter harness connector terminal and meter control switch harness connector terminal.

   Combination meter		Meter control switch		Continuity
   Connector	Terminals	Connector	Terminals
   M53	16	M54	7	Existed
   	36		2
   	37		1
   	39		10
   	40		9
   	38		5

4. Check continuity between combination meter harness connector terminal and ground.

   Combination meter		Ground	Continuity
   Connector	Terminals
   M53	36		Not existed
   	37
   	39
   	40
   	38

Is the inspection result normal?

YES 

INSPECTION END

NO 

Repair harness or connector.