Component Inspection

1. Turn the ignition switch OFF.
2. Disconnect the meter control switch connector.
3. Check continuity of the meter control switch.

   Terminal No.		Operation and status	Continuity
   2	7	When (select) switch is pressed	Existed
   		Other than the above	Not existed
   1	7	When (enter) switch is pressed	Existed
   		Other than the above	Not existed
   5	7	When trip A/B reset switch is pressed	Existed
   		Other than the above	Not existed
   10	7	When (illumination control) switch is pressed	Existed
   		Other than the above	Not existed
   9	7	When (illumination control) switch is pressed	Existed
   		Other than the above	Not existed

Is the inspection result normal?

YES 

INSPECTION END

NO 

Replace the meter control switch.