Transfer Fluid: Refilling

WARNING: This page is about a different variant/trim than selected.

Remove filler plug and gasket. Then fill fluid up to mounting hole for the filler plug.

Fig 1: Checking Fluid Level From Filler Plug Mounting Hole
Courtesy of NISSAN NORTH AMERICA, INC.

Recommended fluid and capacity : Refer to FLUIDS AND LUBRICANTS .

CAUTION:
Carefully fill the fluid. (Fill up for approximately 3 minutes.)
Leave the vehicle for 3 minutes, and check the fluid level again.
Set a new gasket onto filler plug, and install it on transfer and tighten to the specified torque. Refer to EXPLODED VIEW .
CAUTION:
Never reuse gasket.