LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> Q50 Base, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (Exc Hybrid)) >> DTC/Circuit Diagnosis >> DTC U1000: Can Comm Circuit >> DTC Description >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different variant/trim than selected.

  1. PRECONDITIONING

    If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

    GO TO STEP 2  .

  2. DTC REPRODUCTION PROCEDURE

    With CONSULT 

    1. Turn the ignition switch OFF to ON.
    2. Perform self-diagnosis for "ALL MODE AWD/4WD".

    Is DTC "U1000" detected?

    YES 

    Proceed to diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .

    NO-1 

    To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

    NO-2 

    Confirmation after repair: INSPECTION END

scientia non olet · About LEMON Manuals