DTC Confirmation Procedure
WARNING: This page is about a different variant/trim than selected.
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO STEP 2 .
- DTC REPRODUCTION PROCEDURE
With CONSULT
- Start the engine and drive at 30 km/h (19 MPH) or more for approximately 1 minute.
- Perform self-diagnosis for "ALL MODE AWD/4WD".
Is DTC "C1203" detected?
YES
Proceed to diagnosis procedure. Refer to DIAGNOSIS PROCEDURE .
NO-1
To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .
NO-2
Confirmation after repair: INSPECTION END