Diagnostic Test
- CHECK FRONT AND REAR AXLE
Check that there is no excessive looseness in front and rear axle.
- Front axle
- 2WD: Refer to INSPECTION .
- AWD: Refer to INSPECTION .
- Rear axle: Refer to INSPECTION .
Is the inspection result normal?
YES
GO TO STEP 2 .
NO
Repair / replace error-detecting of front or rear axle part.
- Front axle
- CHECK DISC ROTOR
Check disc rotor runout.
- Front: Refer to INSPECTION AND ADJUSTMENT .
- Rear: Refer to INSPECTION AND ADJUSTMENT .
Is the inspection result normal?
YES
GO TO STEP 3 .
NO
Refinish the disc rotor.
- CHECK BRAKE FLUID LEAKAGE
Check fluid leakage.
- Front: Refer to INSPECTION .
- Rear Refer to INSPECTION .
Is the inspection result normal?
YES
GO TO STEP 4 .
NO
Repair / replace fluid leakage part.
- CHECK BRAKE PEDAL
Check each item of brake pedal. Refer to INSPECTION AND ADJUSTMENT .
Is the inspection result normal?
YES
GO TO STEP 5 .
NO
Adjust each item of brake pedal. Refer to INSPECTION AND ADJUSTMENT .
- CHECK BRAKING FORCE
Check brake force using a brake tester.
Is the inspection result normal?
YES
GO TO STEP 6 .
NO
Check each components of brake system.
- CHECK BRAKE PERFORMANCE
Disconnect ABS actuator and electric unit (control unit) connector so that ABS does not operate. Check that brake force is normal in this condition. Connect harness connectors after checking.
Is the inspection result normal?
YES
Normal
NO
Check each components of brake system.