Diagnostic Test
- ADJUST THE NEUTRAL POSITION OF STEERING ANGLE SENSOR
Perform neutral position adjustment of steering angle sensor. Refer to DESCRIPTION .
GO TO STEP 2 .
- CHECK ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
With CONSULT
- Turn the ignition switch OFF → ON.CAUTION:
- Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
- Start the engine.
- Repeat step 1 two or more times.
- Perform self-diagnosis for "ABS".
Is DTC "C1144" detected?
YES
GO TO STEP 3 .
NO
INSPECTION END
- Turn the ignition switch OFF → ON.
- CHECK STEERING ANGLE SENSOR SYSTEM
- Turn the ignition switch OFF.
- Check the steering angle sensor system. Refer to DIAGNOSIS PROCEDURE .
Is the inspection result normal?
YES
Replace the ABS actuator and electric unit (control unit). Refer to REMOVAL AND INSTALLATION .
NO
Repair / replace harness, connector, or terminal.