Diagnostic Test

1. Turn the ignition switch OFF.
2. Disconnect stop lamp switch harness connector.
3. Check the continuity when stop lamp switch is operated.

   Stop lamp switch	Condition	Continuity
   Terminal
   -*1 -*2	When stop lamp switch is released (When brake pedal is depressed)	Existed
   	When stop lamp switch is pressed (When brake pedal is released)	Not existed

   *1: Models with ICC

   *2: Models without ICC

Is the inspection result normal?

YES 

INSPECTION END

NO 

Replace the stop lamp switch. Refer to REMOVAL AND INSTALLATION .