Diagnostic Test

Perform the trouble diagnosis for ABS actuator and electric unit (control unit) power supply and ground circuit. Refer to DIAGNOSIS PROCEDURE .

Is the inspection result normal?

YES 

GO TO STEP 2  .

NO 

Repair / replace harness, connector, fuse, or fusible link.

With CONSULT

1. Turn the ignition switch OFF → ON.
   CAUTION:

   • Be sure to wait of 10 seconds after turning ignition switch OFF or ON.
   • Start the engine.
2. Repeat step 1 two or more times.
3. Perform self-diagnosis for "ABS".

Is any DTC detected?

YES 

Check the DTC. Refer to DTC INDEX .

NO 

GO TO STEP 3  .

With CONSULT

1. Select "ABS", "DATA MONITOR" and "ABS WARN LAMP" according to this order.
2. Turn the ignition switch OFF.
3. Check that data monitor displays "On" for 1 second after ignition switch is turned ON and then changes to "Off".
   CAUTION:

   Never start the engine.

Is the inspection result normal?

YES 

Replace the combination meter. Refer to REMOVAL AND INSTALLATION .

NO 

Replace the ABS actuator and electric unit (control unit). Refer to REMOVAL AND INSTALLATION .