LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> Q50 Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio, Visual & Navigation System (INFINITI INTOUCH) (Introduction) (Exc Hybrid) >> Basic Inspection >> Inspection And Adjustment >> Configuration (Display Control Unit) >> Work Procedure

Work Procedure

  1. WRITING MODE SELECTION

    CONSULT Configuration

    Select "Re/programming, Configuration" of "MULTI AV".

    When writing saved data 

    GO TO STEP 2  .

    When writing manually 

    GO TO STEP 3  .

  2. WRITING VEHICLE SPECIFICATION

    CONSULT Configuration

    Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to display control unit.

    CAUTION:

    Do not perform any operation such as the navigation operation during configuration writing.

    GO TO STEP 4  .

  3. WRITE VEHICLE SPECIFICATION

    CONSULT Configuration

    Select "Manual Configuration", and write the setting value as shown in the following table to display control unit according to the vehicle specification.

    CAUTION:

    Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.

    NOTE:
    • The items shown in this list depend on vehicle specifications.
    • The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
    • If selection items are not displayed on the CONSULT screen, touch "NEXT".
    MANUAL SETTING ITEM Detail
    Items Setting value
    STEERING LHD LHD models
    RHD RHD models
    NAVIGATION WITH Models with navigation
    WITHOUT Models without navigation
    LDP (LANE DEPARTURE PREVENTION) On Models with LDP
    Off Models without LDP
    ENGINE TYPE VQ ENGINE VQ engine models
    EXCEPT FOR VQ ENGINE Except VQ engine models
    HYBRID OFF Except hybrid models
    FR TYPE Hybrid models (2WD)
    FR TYPE 4WD Hybrid models (4WD)
    CAMERA SYSTEM REAR CAMERA With rear view monitor system
    NONE/AVM ph3 With around view monitor system
    PREDICTIVE COURSE LINE WITHOUT/WITH AVM With around view monitor system
    WITH (RVM WITHOUT DAST) With rear view monitor system without direct adaptive steering
    WITH (RVM WITH DAST) With rear view monitor system and direct adaptive steering
    TRANSMISSION AT/CVT A/T models
    MT M/T models
    SONAR TYPE NONE Models without sonar
    FRONT & REAR Models with sonar
    AUDIO AMP TYPE 160W AMP Models without BOSE system
    2ch AMP Models with BOSE system
    DAB FUNCTION Off Models without DAB (digital audio broadcast) function
    On Models without DAB (digital audio broadcast) function

    GO TO STEP 5  .

  4. PERFORM SELF-DIAGNOSIS

    CONSULT Self Diagnostic Result

    Perform self-diagnosis of CONSULT, and check whether or not DTC U1223 is detected.

    Is DTC U1223 detected?

    YES 

    GO TO STEP 3  .

    NO 

    GO TO STEP 5  .

  5. OPERATION CHECK

    Check that the operation of the display control unit and camera images (fixed guide lines and predictive course lines) are normal.

    WORK END

scientia non olet · About LEMON Manuals