DTC Confirmation Procedure

With CONSULT

1. Turn ignition switch ON.
2. Turn ignition switch OFF and wait at least 30 seconds.
3. Turn ignition switch ON and wait at least 30 seconds or more.
4. Shift the selector lever to R position and than, shift the selector lever to P position again.
5. Select "Self Diagnostic Result" mode of "MULTI AV" using CONSULT.
6. Check DTC.

Is DTC U12B8 detected?

YES 

Proceed to DIAGNOSIS PROCEDURE .

NO-1 

To check malfunction symptom before repair: Refer to INTERMITTENT INCIDENT .

NO-2 

Confirmation after repair: INSPECTION END