LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2015 >> Q50 Base, RWD >> Repair and Diagnosis >> Accessories & Equipment >> Infotainment >> Audio, Visual & Navigation System (Around View Monitor System - Diagnostic Trouble Codes (DTCS) & Symptom Tests) (Exc Hybrid) >> DTC/Circuit Diagnosis >> Power Supply And Ground Circuit >> Around View Monitor Control Unit >> Diagnosis Procedure

Diagnosis Procedure

  1. CHECK FUSE

    1. Turn ignition switch OFF.
    2. Check that the following fuse is not fusing.
      Power source Fuse No. Capacity
      Battery #7 15 A
      Ignitions switch ACC #1 10 A
      Ignition switch ON #14 5 A

    Is the fuse fusing?

    YES 

    Replace fuse after repairing the applicable circuit.

    NO 

    GO TO STEP 2  .

  2. CHECK POWER SUPPLY CIRCUITS

    Check voltage between around view monitor control unit harness connector and ground.

    Signal name Terminals Ignition switch position Value (Approx.)
    (+) (-)
    Around view monitor control unit
    Connector Terminal
    Battery power supply B50 2 Ground OFF Battery voltage
    ACC power supply 4 ACC
    Ignition signal 3 ON

    Is inspection result normal?

    YES 

    GO TO STEP 3  .

    NO 

    Check harness between around view monitor control unit and fuse.

  3. CHECK GROUND CIRCUIT

    1. Turn ignition switch OFF.
    2. Disconnect around view monitor control unit connector.
    3. Check continuity between around view monitor control unit harness connector and ground.
      Terminals Continuity
      (+) (-)
      Around view monitor control unit
      Connector Terminal
      B50 1 Ground Existed

    Is inspection result normal?

    YES 

    INSPECTION END

    NO 

    Repair harness or connector.

scientia non olet · About LEMON Manuals