Values On The Diagnosis Tool
| Monitor Item | Condition | Value/Status |
|---|---|---|
| LDW SW PORT |
NOTE:
The item is indicated, but not used |
- |
| LDP ON IND |
NOTE:
The item is indicated, but not used |
- |
| LANE DPRT W/L |
NOTE:
The item is indicated, but not used |
- |
| CAM HIGH TEMP | When the temperature around lane camera unit is adequate | NORMAL |
| When the temperature around the lane camera unit is high | High | |
| VHCL SPD SE | While driving | Approximately equivalent to speedometer reading |
| TURN SIGNAL | Turn signal lamp LH and RH blinking | LH/RH |
| Turn signal lamp LH blinking | LH | |
| Turn signal lamp RH blinking | RH | |
| Turn signal lamps OFF | Off | |
| LANE DETCT LH | Left side lane marker is detected | On |
| Left side lane marker is not detected | Off | |
| LANE DETCT RH | Right side lane marker is detected | On |
| Right side lane marker is not detected | Off | |
| CROSS LANE LH | The vehicle is crossing left side lane marker | On |
| The vehicle is not crossing left side lane marker | Off | |
| CROSS LANE RH | The vehicle is crossing right side lane marker | On |
| The vehicle is not crossing right side lane marker | Off | |
| WARN LANE LH | The vehicle is traveling on the left side lane marker. | On |
| The vehicle is traveling the center of traffic lane. | Off | |
| WARN LANE RH | The vehicle is traveling on the right side lane marker. | On |
| The vehicle is traveling the center of traffic lane. | Off | |
| VALID POS LH | Lateral position for left side lane marker is valid | VLD |
| Lateral position for left side lane marker is invalid. | INVLD | |
| VALID POS RH | Lateral position for right side lane marker is valid. | VLD |
| Lateral position for right side lane marker is invalid. | INVLD | |
| LATERL POS LH | Left side lane marker is detecting. | Displays the distance from a lane camera to the left lane marker. |
| LATERL POS RH | Right side lane marker is detecting. | Displays the distance from a lane camera to the right lane marker. |
| CURVATURE | Lane marker is detecting. | Displays the road curvature that a lane camera detected. |
| LATERAL SPEED | Lane marker is detecting. | Displays lateral speed for the lane of the vehicle. |
| YAW ANGLE | Lane marker is detecting. | Displays yaw angle for the lane of the vehicle. |
| CAM DTC CODE |
NOTE:
The item is indicated, but not used. |
|
| AIMING DONE | Camera aiming is completed | OK |
| Camera aiming is not adjusted | NG | |
| AIMING RESULT | Camera aiming is completed | OK |
| Camera aiming is not completed | NOK | |
| AIM NG REASON | No target is detected. | TARGET |
| Yaw angle beyond the allowable range is detected. | YAW | |
| Roll angle beyond the allowable range is detected. | ROLL | |
| Pitch angle beyond the allowable range is detected. | PITCH | |
| The target is unclear. | IMAGE | |
| Lighting is insufficient. | LIGHT | |
| One side target is not detected. | 1-SIDE | |
| Other NG is detected. | OTHERS | |
| RUNTIME AIM |
NOTE:
The item is indicated, but not used |
- |
| INITIALIZE |
NOTE:
The item is indicated, but not used |
- |
| RUNTIME AIMOFFSET (YAW) |
NOTE:
The item is indicated, but not used |
- |
| RUNTIME AIM WORK COND |
NOTE:
The item is indicated, but not used |
- |
| RUNTIME AIM MEMORIZING |
NOTE:
The item is indicated, but not used |
- |
| XOFFSET |
NOTE:
The item is indicated, but not used |
- |
| RUNTIME AIMOFFSET (PITCH) |
NOTE:
The item is indicated, but not used |
- |
| AIM CHECK YAW |
NOTE:
The item is indicated, but not used |
- |
| AIM CHECK ROLL |
NOTE:
The item is indicated, but not used |
- |
| AIM CHECK PITCH |
NOTE:
The item is indicated, but not used |
- |
| FOE X |
NOTE:
The item is indicated, but not used |
- |
| FOE Y |
NOTE:
The item is indicated, but not used |
- |
| RUNTIME FOE X |
NOTE:
The item is indicated, but not used |
- |
| RUNTIME FOE Y |
NOTE:
The item is indicated, but not used |
- |
| FCTRY AIM YAW | Camera aiming is completed | 0 +- 2.0 deg |
| FCTRY AIM ROL | Camera aiming is completed | 0 +- 2.0 deg |
| FCTRY AIM PIT | Camera aiming is completed | 0 +- 2.0 deg |
| RUNTIME AIM COUNT |
NOTE:
The item is indicated, but not used |
- |
| ROM WRITING COUNT |
NOTE:
The item is indicated, but not used |
- |
| CAMERA START | Lane camera unit is starting. | START |
| Lane camera unit starting is completed. | COMP | |
| GIVE UP | Lane marker can be detected. | OK |
| Lane marker can not be detected. | NG | |
| READY | Operating conditions are not satisfied. | NOT |
| Operating conditions are satisfied. | COMP | |
| MARK TYPE LH | Lane marker is not detected | NONE |
| Solid line is detected. | SOLID | |
| Dashed line is detected. | DASHED | |
| Bott's dots is detected. | BOTT's | |
| Fork road (bifurcation) is detected. | FORK | |
| Slow down area is detected. | SLOW | |
| Tar strips is detected. | TAR | |
| Irregularity road is detected. | IRGLTY | |
| MARK TYPE RH | Lane marker is not detected | NONE |
| Solid line is detected. | SOLID | |
| Dashed line is detected. | DASHED | |
| Bott's dots is detected. | BOTT's | |
| Fork road (bifurcation) is detected. | FORK | |
| Slow down area is detected. | SLOW | |
| Tar strips is detected. | TAR | |
| Irregularity road is detected. | IRGLTY | |
| CAMERA OFFSET HEIGHT (Dh) | Camera aiming is completed | Displays camera height correction value (Dh). |
| TARGET HEIGHT (Ht) | Camera aiming is completed | Displays height (Ht) of the aiming target. |
| TARGET DISTANCE (Dt) | Camera aiming is completed | Displays the distance (Dt) from front axle to a target. |