Diagnosis Procedure

1. Turn the ignition switch OFF.
2. Disconnect the battery cable from the negative terminal.
3. Check the following terminals and connectors for damage, bend and loose connection (unit side and connector side).
   • Side radar LH
   • Harness connector B87
   • Harness connector B8

Is the inspection result normal?

YES 

GO TO STEP 2  .

NO 

Repair the terminal and connector.

1. Disconnect the connector of side radar LH.
2. Check the resistance between the side radar LH harness connector terminals.

   Side radar LH harness connector			Resistance (Ω)
   Connector No.	Terminal No.
   B92	4	3	Approx. 54 - 66

Is the measurement value within the specification?

YES 

GO TO STEP 3  .

NO 

Replace the body harness.

Check the power supply and the ground circuit of the side radar LH. Refer to DIAGNOSIS PROCEDURE .

Is the inspection result normal?

YES (Present error) 

Replace the side radar LH. Refer to REMOVAL AND INSTALLATION .

YES (Past error) 

Error was detected in the side radar LH branch line.

NO 

Repair the power supply and the ground circuit.