Work Procedure
WARNING:
Be careful of traffic conditions and safety around the vehicle when performing road test.
CAUTION:
Fully understand the following items well before the road test;
- Precautions: Refer to BCI SYSTEM SERVICE .
- System description for BCI: Refer to SYSTEM DESCRIPTION .
- Normal operating condition: Refer to DESCRIPTION .
- CHECK BCI SYSTEM SETTING
Check the sonar system operation. Refer to SYSTEM DESCRIPTION .
GO TO STEP 2 .
- CHECK BCI SYSTEM SETTING
- Start the engine.
- Check that the BCI system setting can be enabled/disabled on the integral switch.
- Turn OFF the ignition switch and wait for 30 seconds or more.
- Check that the previous setting is saved when the engine starts again.
GO TO STEP 3 .
- ACTION TEST FOR BCI
- Enable the setting of the BCI system on the integral switch.
- Check the BCI operation according to the following table.
Vehicle condition Action Buzzer - R range
- 0 km/h (0 MPH)
If the radar detects an approaching vehicle from the side - Chime sound (single beep)
- Flashes Blind Spot Warning/Blind Spot Intervention indicator on the side of the approaching vehicle is detected
- Yellow rectangular frame appears in the display
Single beep No approaching vehicle No action -
INSPECTION END