Diagnosis Procedure
- CHECK TRIP RESET AND ILLUMINATION CONTROL SWITCH SIGNAL CIRCUIT
Check the trip reset and illumination control switch signal circuit. Refer to "DIAGNOSIS PROCEDURE ".
Is the inspection result normal?
YES: GO TO 2.
NO: Repair harness or connector.
- CHECK TRIP RESET AND ILLUMINATION CONTROL SWITCH
Perform a unit check for the trip reset and illumination control switch. Refer to "COMPONENT INSPECTION ".
Is the inspection result normal?
YES: Replace combination meter. Refer to "REMOVAL AND INSTALLATION ".
NG: Replace trip reset and illumination control switch. Refer to "REMOVAL AND INSTALLATION ".