Diagnosis Procedure
WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.
Regarding Wiring Diagram information, refer to WIRING DIAGRAM .
- CHECK DISK EJECT SIGNAL CIRCUIT CONTINUITY
- Turn ignition switch OFF.
- Disconnect AV control unit connector M125 and multifunction switch connector.
- Check continuity between AV control unit connector M125 terminal 97 and multifunction switch connector M98 terminal 14.
AV control unit Multifunction switch Continuity Connector Terminal Connector Terminal M125 97 M98 14 Yes - Check continuity between AV control unit connector M125 terminal 978 and ground.
AV control unit Ground Continuity Connector Terminal M125 97 No
Is inspection result normal?
YES
GO TO STEP 2 .
NO
Repair or replace harness or connectors.
- CHECK AV CONTROL UNIT VOLTAGE
- Connect AV control unit connector M125 and multifunction switch connector.
- Turn ignition switch ON.
- Check voltage between AV control unit connector M125 terminal 97 and ground.
AV control unit Ground Condition Voltage
(Approx.)(+) (-) Connector Terminal M125 97 - Pressing eject switch 0 V Except above 5.0 V
Is the inspection result normal?
YES
Replace AV control unit. Refer to REMOVAL AND INSTALLATION .
NO
Replace multifunction switch. Refer to REMOVAL AND INSTALLATION .