Work Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE SERIAL NUMBER (PART 1)

Write down the serial number of new transaxle assembly.

Courtesy of NISSAN NORTH AMERICA, INC.

GO TO STEP 2 .

CHECK THE SERIAL NUMBER (PART 2)
1. Turn ignition switch ON.
2. Insert the attached CD into CONSULT.
3. Select "Work Support" in "TRANSMISSION".
4. Select "WRITE IP CHARA - REPLACEMENT AT/CVT".
5. Check that the serial number displayed on CONSULT screen and those written in the memo agree.
  CAUTION:
  Never perform writing procedure.
6. Go back to MENU of "Work Support".
GO TO STEP 3 .

INITIALIZE TCM
1. Set parking brake.
2. Select "ERASE MEMORY DATA".
3. Touch "Start" according to the instructions on the CONSULT screen.
Is "COMPLETED" displayed?

YES

GO TO STEP 4 .

NO

Turn ignition switch OFF and wait for a minimum of 10 seconds then perform the work again.

WRITE THE DATA

NOTE:
Write data of new solenoid in TCM according to the following instructions:
1. Shift the selector lever to the P position.
2. Turn ignition switch OFF and wait for 10 seconds.
3. Turn ignition switch ON.
4. Select "Work Support" in "TRANSMISSION".
5. Select "WRITE IP CHARA - REPLACEMENT AT/CVT".
6. Write data in TCM according to the instructions on the CONSULT screen.
  NOTE:
  When writing is complete, the shift position indicator of the combination meter displays P.
GO TO STEP 5 .

ERASE CVT FLUID DEGRADATION LEVEL DATA
1. Select "WORK SUPPORT" in "TRANSMISSION".
2. Select "CONFORM CVTF DETERIORTN".
3. Touch "Clear".
WORK END