Work Procedure

WARNING: This page is about a different car, the 2016 Infiniti QX60. However, it is still accessible from the selected car via links, so may be relevant.

SAVE TCM DATA (VEHICLE SPECIFICATIONS)

With CONSULT
1. Turn ignition switch OFF.
2. Connect all of disconnected connectors.
3. Turn ignition switch ON.
4. Select "Re/programming, Configuration".
5. Select "AT/CVT".
  NOTE:
  If "AT/CVT" is not displayed and TCM data cannot be saved on CONSULT, GO TO 2.
6. Select "Programming".
7. Save TCM data on CONSULT according to the CONSULT display.
GO TO STEP 2 .

REPLACE TCM AND TRANSAXLE ASSEMBLY

Turn ignition switch OFF and wait for 10 seconds.

Replace TCM and transaxle assembly. Refer to REMOVAL AND INSTALLATION (TCM), REMOVAL AND INSTALLATION (Transaxle assembly).

CAUTION:

Write down the serial number of new transaxle assembly.

Courtesy of NISSAN NORTH AMERICA, INC.

GO TO STEP 3.

WRITE TCM DATA (VEHICLE SPECIFICATIONS)

NOTE:
Write data saved in CONSULT into a new TCM according to the following instructions:

With CONSULT
1. Select "Programming".
2. Perform programming according to the CONSULT display.
GO TO STEP 4.

WRITE TCM DATA (IP CHARACTERISTICS VALUE)

NOTE:
Write data of new solenoid in TCM according to the following instructions:

With CONSULT

CAUTION:
When the work is interrupted, obtain data again from the supplied CD.
1. Shift the selector lever to the P position.
2. Turn ignition switch OFF and wait for 10 seconds.
3. Turn ignition switch ON.
4. Insert the supplied CD into CONSULT.
5. Select "Work Support" in "TRANSMISSION".
6. Select "WRITE IP CHARA - REPLACEMENT AT/CVT".
7. Check that the serial number displayed on CONSULT screen and those written in the memo agree.
8. Write data in TCM according to the instructions on the CONSULT screen.
  NOTE:
  When writing is complete, the shift position indicator of the combination meter displays P.
GO TO STEP 5 .

PERFORM CLUTCH 1 ZERO POSITION LEARNING

Refer to DESCRIPTION .

WORK END